 |
 |
 |
|
Part Number : US-RQ103-LED-40K
Wattage : 50w Equivalent
The USA Light and Electric RetroQuik Recessed LED is the patented all-in-one solution.
Everything you need to install a LED Recessed light! Just cut a hole, connect the electrical and install into the ceiling. The Housing, Trim and LED Light - ALL IN ONE! Watch our video below for more information. Found exclusively at USALight.com!
Bulb Type - 3" Recessed LED
Wattage - 6w
Voltage - 120v
Color Temp - 4000K
Lumens - 400lm
CRI - 90
Beam Angle - 95.8°
Outer Diameter: 3 15/16"
Height: 3 1/2"
Cut Template Included
Insulation Compliant (IC)
Introducing RetroQuik LED Recessed Lighting
- COMPATIBLE DIMMERS
- Although this product is compatible with most common residential type dimmers, performance depends on dimmer, dimmer
- setting, wiring method, and the number of LED modules.
- Recommended Dimmers: Lutron SCL-153P, SCL-153PH, LGCL-153P, LGCL-153PLH, DVCL-153PR and TGCL-153PH
-
Dimmable range from 5% to 100%. When there is a mismatch between the - dimmer and the LED, which makes the LED stroboscopic, then slide the adjustment dial on the side of the dimmer to adjust
- until the LED stops blinking.
|
|
|
 |
|
 |
|
|
|
 |
|
 |
|
Features
- • 50 watt equivalent bulb for 10 watts
• Fits in existing recessed lighting
• No glare
• Safe for the environment
• Projects no heat into a room
• 5-Year product warranty (limited)
• Estimated yearly energy cost: $1.05 based on 4 hrs/day, $0.11/kWh
ADDITIONAL INFORMATION
• Dimming range from 5% to 100%
• Risk of fire or electrical shock. Disconnect power at fuse or circuit breaker before inspection, installation or removal.
• Do not open. No user serviceable parts inside. Warranty void if opened.
• Installation should be performed only by a qualified electrician in accordance with the National Electrical Code and relevant local code.
• This recessed luminaire is intended for mounting only in a covered ceiling where only the lighted side of the luminaire is exposed.
• Not all existing recessed housings will be compatible with this product. To ensure compatibility a test installation should be conducted.
• Suitable for damp locations. Not for use where directly exposed to the weather or water.
• To prevent injury or property damage, only use in fixtures that can structurally support a lamp weighing 0.90lb.
• Not intended for use with emergency exit fixtures or emergency exit lights.
• To prevent early failure, lamp should be installed in an operating environment ranging from -4 degrees F/-20 degrees C and +95 degrees F/+35 degrees C
• Use only on 120VAC-60Hz circuits
|
|
|
|
|
|
|
2 fixtures burned out as soon as they were energiz