 |
 |
 |
 |
|
 |
|
Features
Construction
▪ Single Wall IC Rated for direct contact with insulation, for use in IC and non-IC conditions.
▪ Housing adjusts in frame to accommodate up to 1 1/4" ceiling thickness.
▪ Lamp: 120V, MR16 GU10 LED (Not Included). Lamp Holder: Twist-and-Lock GU10 MR16 Lamp Holder. Airtight housing with gasket to restrict airflow in accordance with ASTM E-283 air-tight requirements.
▪ Steel Housing for greater heat dissipation. Stamped Galvanized steel frame.
Junction Box
▪ Positioned to accommodate straight conduit runs.
▪ Seven (7) 1/2" trade size conduit knockouts, Four (4) 3/4" knockouts with pry-out knockout slots. Four (4) Romex pry-outs with strain relief.
▪ See installation sheet for detailed information
Installation
▪ Designed for ceiling plenums where 2x6 joists or taller are used. Maximum Hole cutout is 3 5/8".
▪ Suitable for T-grid and drop ceiling applications. See ELCO installation sheet for detailed information.
Electrical
▪ Input Voltage: 120VAC. Thermally protected against improper lamping.
Dimmability
▪ Based on lamp selection.
Compatible Trims
▪ Compatible with - ELCO 3" MR16 Trims. Lamp: Designed for use with GU10 MR16 LED: Sold Separately!
Listing
▪ UL Listed for Damp Locations. UL Listed Wet Location with select trims, UL Listed for Feed Through
▪ Airtight per ASTM E-283. Install a JA8-2016-E Lamp/Luminaire for Title 24 Compliance
▪ UL Listed for Direct Contact with Insulation and Combustible Materials.
|
|
|
|
|
|
|
