Home > Recessed Lighting > Four Inch Recessed Lighting > Four Inch Recessed 12 volt >

4" 35W Low Voltage Noise Free Shallow Non-IC Housing

CUSTOMER REVIEWS

Price: $58.14

Qty:

Description

Technical Specs

Shipping Time

Part Number: US-TRBL4E-S

Small aperture, low voltage, thermally protected, specification grade recessed shallow housing. For new construction, non-insulated ceilings or where insulation can be kept 3" from the housing. Accommodates up to 35W MR16 lamps. Furnished with preinstalled adjustable bar hangers.

Features

HOUSING - High temperature painted 22 gauge deep drawn single piece housing. Adjusts vertically in plaster frame to accommodate
½" to 1-3/8" ceiling. Accommodates lamps up to 35W depending on trim used.

TRANSFORMER - Class II dimming electronic transformer enhanced in heat dissipating cover attached to junction box cover.

BAR HANGERS - Preinstalled bar hangers allow housing to be positioned and locked at any point within a 24" joist span and can be shortened for 12" joists. They contain a double-headed real nail for secure attachment into the joist. Bar hanger nails are installed on a 20° downward angle for better contact, and the 90° pivoting mounting plate makes installation fast and accurate. Bar hangers can fit onto T-Bar spline with additional slots and holes for special mounting methods if necessary.

JUNCTION BOX - ETL listed for through-branch circuit wiring and has four ½" KOs, one ¾" KO and four Romex knockouts with true pry-out slots and strain clamps.
• Integral low voltage electronic transformer to eliminate noise and vibration, increasing lamp life and lighting quality.
• Thermally Protected Non-IC housing.
• Designed for accent and task lighting applications.
• Wire through junction box.
• Preinstalled adjustable bar hangers.
• Dependable, favorable design and effortless installation.
• 3-5/8" height allows use in 2" x 4" joist construction.
• Special screw on the frame locks bar hangers in place which prevents the housing from any movement once installed.
*Note: Not compatible with LED bulbs as they do not put enough load on the electronic transformer. Will cause premature failure.
We do not recommend pre-cutting any holes until housings are on site.